800°C Vacuum Furnace (Metal Inner Chamber, Metal Radiation Shields, Elevating Sealed Material Platform)

800℃ vacuum furnace, vertical external heating design with 316L stainless steel liner, metal radiation shield and lifting sealed loading platform. Zoned Ni-Cr strip heaters and 4 thermocouples. Cold vacuum better than 5×10⁻¹Pa, pressure rise ≤0.6Pa/h, supports inert gas slight positive pressure protection for metal vacuum heat treatment.

Elevator Furnace

800°C Vacuum Furnace (Metal Inner Chamber, Metal Radiation Shields, Elevating Sealed Material Platform)

Working temperature:≥800°C
Heating rate:Adjustable from 5°C/min to 20°C/min
Cold-state vacuum:Better than 5×10⁻¹ Pa
Pressure rise rate:≤0.6 Pa/h
Service life of main structure:Not less than 10 years
Retort material:316L stainless steel

Product Video

**1. Structure**

  •  The system is externally heated, resistance-heated, and vertical in structure. It mainly consists of the furnace body, heating system, insulation system, and inner retort.
  • Working temperature ≥800°C; heating rate adjustable from 5°C/min to 20°C/min; cold-state vacuum better than 5×10⁻¹ Pa; pressure rise rate ≤0.6 Pa/h.
  • (It can be filled with inert gas to a slight positive pressure for protection.) The service life of the furnace body and other main structures is not less than 10 years.

2. Furnace Body

  • Material: The retort is 316L stainless steel; the upper and lower furnace bodies are carbon steel.
  • The outer surface is coated with anti-rust paint, thickness 60μm–80μm.
  • The furnace body door opens from the bottom.
  • Process ports are provided on the furnace body: vacuum port, gas inlet, gas release port, thermocouple port, etc.
  • Inspection: 24-hour leak test (compressed air pressure: 0.098 MPa).

Insulation Layer

  •  Structure: Corresponding to the upper, middle, and lower heaters, it is a segmented independent structure, facilitating heater maintenance and replacement.
  • Accessories: Pre-embedded high-temperature-resistant ceramic screws for supporting and fixing the heaters.

3. ★ Heating Body

  •  Material: Nickel-chromium alloy strip, 3 mm thick, with a low surface load, suitable for long-term use under high-temperature atmospheric conditions.
  • Structure: Distributed outside the furnace body, divided into three zones: upper, middle, and lower, with power levels in the order of lower, middle, and upper.
  • Equipped with 4 thermocouples: three located respectively at the upper, middle, and lower zones and forming closed-loop circuits with the heating power supply for temperature control; one independent thermocouple located in the middle for over-temperature alarm.
  • **Note:** The furnace door is of the lifting type; the inner retort is 310L, vacuum-pumped, with a reserved fan port.
Connect with Us Today
Phone Phone:+86-13937922703
Email Email:luoyanganjing@gmail.com